Der Blätterkatalog benötigt Javascript.
Bitte aktivieren Sie Javascript in Ihren Browser-Einstellungen.
The Blätterkatalog requires Javascript.
Please activate Javascript in your browser settings.
11 Read the instructions carefully Be familiar with the controls and the correct use of the machine Read all safety warnings and all instructions Specified Conditions of Use The ORSY® SystemScanner Barcode Direkt is an ordering system permanently installed at your storage location that transfers scanned barcodes directly to a Würth server The system is designed for 24-hour operation and is permanently in standby • The barcode scanner may only be operated together with the router supplied • Installation and instruction are carried out by our Würth employees so that you do not have to make any settings yourself • The light has to be installed and maintained by a qualified specialist • Do not use this product in any other way as stated for normal use • Any repairs must only be carried out by the manufacturer or authorised service agent Use only genuine Würth accessories and spare parts Things to know • There is no internal memory all items are transferred to the Würth server in real time There they are collected and forwarded to logistics for picking according to an adjustable schedule The determination of the transmission time is defined together with you by one of our employees Changes during operation are possible at any time by the office staff • The enclosed router is preconfigured and already contains a Würth SIM card for the Orsy® WLAN During operation the ID of the router and the EAN code are transmitted per item Safety instructions • Never place the device near heat sources Keep the device away from open flames • Switch off the device if it will not be used for a long time • Never disassemble open or modify the device in any way Warning Danger of short circuiting To reduce the risk of fire personal injury and product damage due to a short circuit never immerse your tool battery pack or charger in fluid or allow a fluid to flow inside them Corrosive or conductive fluids such as sea - water certain industrial chemicals and bleach or bleach containing products etc Can cause a short circuit Laser radiation Do not stare into the laser beam Use of controls or adjustments or performing procedures other than those specified herein may result in exposure to hazardous visible laser light Avoid the laser beam hitting the eye of an observer even via reflective surfaces like mirrors etc • Do not crush puncture short circuit or place the lithiumion battery in fire or water To reduce the risk of fire or burns do not attempt to open disassemble or service the battery pack • Do not expose the unit to temperatures above 60 °C 140 °F Only charge the battery with the battery charger recommended by the manufacturer Do not deep discharge the battery Do not use damaged batteries • Pacemaker manufacturers recommend maintaining a minimum of 15 cm 6” between a handheld wireless device and a pacemaker to avoid potential interference Therefore persons with pacemakers should not carry the wireless device in a breast pocket If you have any reason to suspect that interference is taking place turn off your wireless device • Do not take note or use the device while driving When driving a vehicle driving is your first responsibility so give full attention to your driving • Observe restrictions on the use of radio devices in fuel depots chemical plants and areas where the air contains chemicals or particles such as grain dust or metal powder as well as any other area where you are advised to turn off your vehicle engine