Der Blätterkatalog benötigt Javascript.
Bitte aktivieren Sie Javascript in Ihren Browser-Einstellungen.
The Blätterkatalog requires Javascript.
Please activate Javascript in your browser settings.
12 Working instructions • Keep work area well lit This ensures that the scanner reliably starts the reading process • The scanner must always be connected to the power cable since the WLAN connection drains the battery quickly • E-Mail See page 23 Operation without cost centre function The scanner reacts to the presentation of an object Hold the barcode directly in the green field • First beep high - Barcode was read • Second beep high - Order item successfully sent to server Operation with cost centre function If the cost centre function is activated a cost centre barcode must first be read Then the item barcodes can be scanned • To do this hold the generated cost centre barcode in the green field before scanning goods • Then you can scan the items as in the operation without cost centre function • When all items have been scanned press the key 2 to log out the cost centre If no barcode is read for 60 seconds the cost centre is automatically logged out for security reasons Now a cost centre barcode must be scanned again in order to be able to import items The cost centre function can be activated or deactivated at any time via the ORSY® office After that it takes an hour for the new setting on the scanner to become active Error messages Fault Possible cause Remedy Item barcode is not read The item barcode is scratched or damaged Use an intact item barcode The second acoustic signal is lower than the first one No Würth item was scanned The scanner can only read and order Würth article barcodes Scanner does not accept item barcode 4 acoustic signals in rapid succession The scanner works with the cost centre function activated Read a cost centre barcode before scanning an item barcode • The WLAN connection was interrupted because the distance to the router is too great • The router is switched off or defective • No mobile network available Switch the device off and on again with the button 1 The scanner must always be within the WLAN radius of the mobile router about 15 metres The blue LED and the green LED flash alternately 3 acoustic signals in quick succession The WLAN connection to the mobile router is not available Switch off the scanner using the On Off button 1 Then disconnect the mobile router from the power supply After about 60 seconds restart the mobile router by reconnecting the device to the power supply Then restart the scanner by pressing the On Off button 1 after about 5 minutes As soon as the green LED lights up continuously and the green field appear when there is movement within the scan window the scanner is ready for use again The green LED flashes WLAN connection is established after switching on Wait until the green LED is constantly lit That means that the WLAN connection is established WLAN connection is weak because the battery has little power Check whether the unit is connected to the provided power supply unit If necessary establish the connec - tion and wait until the green LED is constantly lit That means that the WLAN connection is established The red LED is on Battery has low power Connect the unit to the mains adapter The red LED goes out when the battery is charged